Search This Blog

Friday, May 21, 2010

You can add multiple IP Addresses to a single interface card.

You can add multiple IP Addresses to a single interface card.



1. Open Control Panel and Network Connections.
2. Right-click the LAN connection and select properties.
3. Select Internet Protocol (TCP/IP) and click properties

4. Select "Use the following IP Address" and enter the primary IP Address, Subnet mask and Gateway and the primary and secondary DNS Servers


5. Click Advanced then Add under IP Addresses.
6. Add the IP Address and Subnet mask. Repeat the procedure if there are additional IP Addresses to be added.

7. Click Add under "Default Gateways" and add the gateway addresses
8.Click OK then OK and then OK to save the changes.
9. To confirm the multiple IP Addresses are set, from the command prompt (Start-Run and type CMD) run the ipconfig command. You can see multiple IP addresses on one Network Interface Card.

Deepak Kumar Verma 9214012330

No comments:

Post a Comment